Comments on: SRT100 actuators : Code https://lebois-racing.com/srt100-actuators-code/ Hardware | DIY | Sim Racing Tue, 03 Jan 2023 19:05:16 +0000 hourly 1 https://wordpress.org/?v=6.9.1 By: Markus https://lebois-racing.com/srt100-actuators-code/#comment-363 Tue, 03 Jan 2023 19:05:16 +0000 https://lebois-racing.fr/?p=1575#comment-363 Hello,
we rebuild your setup and have some troubles with the connection to FlyPT. If I start the connection, nothing happens (A0 of the Arduino keeps low). If I change the Start String to C and modify the Arduino Code, the Output A0 gets high and the actuators are moving (too much). Then I had a look at your HBS86H settings. We ordered the motor and driver wich was shown in the shopping list. It seems that we don´t have the V3 – we just have 6 switches. I set our switches to off, off, off, off, on, on (3200 microsteppings) – right? It would be very nice if you can help us a little bit 🙂
Thanks in advance,
Markus

]]> By: Lebois https://lebois-racing.com/srt100-actuators-code/#comment-362 Sat, 28 May 2022 18:30:42 +0000 https://lebois-racing.fr/?p=1575#comment-362 In reply to Tobias.

I am not using simtools

]]> By: Tobias https://lebois-racing.com/srt100-actuators-code/#comment-361 Fri, 27 May 2022 21:04:33 +0000 https://lebois-racing.fr/?p=1575#comment-361 The axis are very short when using simtools, the nema only turns about 1/8 of a turn. is there a way to scale the axis?

]]> By: Lebois https://lebois-racing.com/srt100-actuators-code/#comment-360 Thu, 18 Feb 2021 17:24:54 +0000 https://lebois-racing.fr/?p=1575#comment-360 In reply to Adrià Capdevila Niubó.

well I would say that the easiest way would be to link the switch directly to the enable pins of the driver.

]]> By: Adrià Capdevila Niubó https://lebois-racing.com/srt100-actuators-code/#comment-359 Wed, 17 Feb 2021 13:45:45 +0000 https://lebois-racing.fr/?p=1575#comment-359 I’m trying to introduce limit switches without much success, have you tried it i know how to do it?

]]>