1. Features
2. Shopping list
3. Wiring
4. Code
5. 3D Files

1) Features

The Smart Control Box adds three buttons that can then be used like conventional buttons, and in particular be assigned on FlyPT to the “Connect”, “Increase gain” and “Decrease gain” functions that allows to control the SRT80 actuators.

This page is dedicated for using with FlyPT and Simtools only

The button LEDs are lit when FlyPT is connected.

2) Shopping list

Compared to the basic shopping list, we only need three 12mm buttons. I recommend using the buttons referenced below, which incorporate LEDs that are used to provide feedback: they only light up when FlyPT is connected to the Arduino.

• 3 buttons 12mm with led (3-6V), momentary reset (Aliexpress)
• one Arduino Leonardo (et non uno) (Amazon)

3) Wiring

The three buttons are wired on pins A2, A3 and A4. The LEDs are powered on pin A5.

• Increase Gain – A2
• Decrease Gain – A3
• Connect – A4

As far as the drivers are concerned, there’s nothing to be done.

The buttons have four pins:

One + and one – facing each other (LED function), and two pins for the button function. One of these can be connected to a – :

4) Code

Available here. The FlyPT profile is the same.

5) 3D files

Available here

The post Smart Control Box for the SRT80 actuators with FlyPT appeared first on Lebois Racing.