Lebois Racing

Hardware | DIY | Sim Racing

DIY SRT Projects

Exclusive firmwares for PRO and ELITE patreons !

Lebois2 Comments on Exclusive firmwares for PRO and ELITE patreons !
To view this content, you must be a member of Lebois's Patreon at $5 or more
Unlock with Patreon
Already a qualifying Patreon member? Refresh to access this content.
I've been passionate about cars since I was a kid! I learned the multiple variations of the Skyline R34 through the Gran Tursimo series, until I discovered GTR2 at the wheel of a keyboard. A few years later, I plunged back into Sim Racing with a G27 which made me enter the DIY world. Always looking for an immersion out of reach in reality, I develop projects that I take care to make accessible to any 3D printer owner!
Website https://lebois-racing.com
Posts created 113

2 thoughts on “Exclusive firmwares for PRO and ELITE patreons !”

  1. Pingback: Documentation of the SRT V9.1 gearbox - Lebois Racing

  2. Hi, I upgraded to v10 then upgraded to the new Arduino. I do not have the other little circuit board required for the hall sensor type sequential and I have not reprinted anything as it works fine as a h pattern. I would like to keep the first V10 sequential setup with two switches, but the new board now only has 2 pins, I don’t use any button plates and was wondering if I can now connect the 2 switches to one of those spare 3 pin sockets and copy the old sequential code from somewhere and add it to that spare 3 pin sockets code to get the two switch sequential working again? Cheers

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *

Related Posts

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top