To view this content, you must be a member of Lebois’s Patreon at $5 or more Unlock with PatreonAlready a qualifying Patreon member? Refresh to access this content.
SRT Gearbox V10
Discover the best H-box for sim racing! The icing on the cake: it’s a simple and accessible DIY project! Summary 1) Presentation 2) How to start 3) Shopping list 4) 3D files 5) Assembly 6) Arduino Code 7) Wiring 8)…
Mod Hall Sensor Sequential for the SRT Gearbox v9.1
The Sequential Hall Sensor Mod for the SRT V9.1 gearbox allows hall sensors to be used instead of switches for sequential mode. It is based on the “Sequential Plate” PCB. A magnet is installed in the slider. Summary 1) Shopping…
Sim Racing SRT P1 Seat Belt Tensioner V2
The P1 belt tensioner allows you to feel positive and/or negative Gs in sim racing. It works with FlyPT. It’s a DIY project ! The V2 offers torque gains thanks to a smaller diameter spool. The housing is now total…
Traction loss rig with SRT80 actuators
This article is WIP. Information subject to change without notice. Traction Loss lets you feel the sensation of the rear end of the car drifting. On the chassis side, the shopping list includes two frames: Lower frame: the one that…
Smart Control Box for Simhub
The Smart Control Box is a harness tensioner control box reserved for Pro and Elite contributors. Summary : 1) Presentation The Smart Control Box Uno lets you adjust gain and preload directly, to avoid situations where the tensioner becomes unpleasant…
Seat Belt tensioner P1 : Smart Control Box v2
To view this content, you must be a member of Lebois’s Patreon at $5 or more Unlock with PatreonAlready a qualifying Patreon member? Refresh to access this content.
Smart Control Box for the SRT80 actuators with FlyPT
Summary : 1) Features The Smart Control Box adds three buttons that can then be used like conventional buttons, and in particular be assigned on FlyPT to the “Connect”, “Increase gain” and “Decrease gain” functions that allows to control the…
SRT Gearbox V9.1
I am working on a 6 speeds gearbox that would be controlled by any clutch pedal ! Summary 1) Presentation 2) How to start 3) Shopping list 4) 3D files 5) Assembly 6) Arduino Code 7) Wiring 8) Mods 1…
February Patreons exclusivities !
To view this content, you must be a member of Lebois’s Patreon at $5 or more Unlock with PatreonAlready a qualifying Patreon member? Refresh to access this content.