SRT paddle shifters V1

The SRT paddle shifters are the first ones to be mounted on ball bearings !

Do you want to support this project ?


1) Presentation

2) Caracteristics

3) Shopping list

4) Building instructions




1) Presentation

2) Caracteristics

Magnetic paddle shifter with a bearing mounted lever. The stroke can be tuned. The horizontal position can be tuned. You can inscrease the shifter resistance bt adding more magnets.

3) Shopping list

Electronics :

– two switchs KW11-3Z (Amazon, Aliexpress, Ebay)

Mecanics :

  1. – PLA (Amazon)
  2. 4 screws M2x8mm
  3. 6 screws M3x10mm
  4. 4 screws M4x20mm
  5. 2 screws M4x30mm
  6. 4 nuts M3
  7. 6 nuts M4
  8. 4 or 6 magnets 9x3mm (Aliexpress, Ebay)
  9. 4 bearings 10x15x4 (Amazon, Aliexpress, Ebay)

4) Building instructions

à venir


I've been passionate about cars since I was a kid! I learned the multiple variations of the Skyline R34 through the Gran Tursimo series, until I discovered GTR2 at the wheel of a keyboard. A few years later, I plunged back into Sim Racing with a G27 which made me enter the DIY world. Always looking for an immersion out of reach in reality, I develop projects that I take care to make accessible to any 3D printer owner!
Posts created 100

One thought on “SRT paddle shifters V1

Leave a Reply

Your email address will not be published. Required fields are marked *

Related Posts

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top